Bacharach Fyrite INSIGHT Bedienungsanleitung

Fyrite® INSIGHTCombustion Gas AnalyzerInstruction 24-9460Operation & MaintenanceRev. 0 – Oct. 2008Product Leadership • Training • Service • Reliab

Instruction 24-946014Fyrite® INSIGHTInstruction 24-946015Fyrite® INSIGHTlated data no matter what zoom level has been selected. Select the desired zo

Instruction 24-946016Fyrite® INSIGHTInstruction 24-946017Fyrite® INSIGHTChange the order in which data is displayed as follows:1. Enter the SETUP MENU

Instruction 24-946018Fyrite® INSIGHTInstruction 24-946019Fyrite® INSIGHTNOTE: The default CAL Reminder period is set to NEVER. Set the calibration re

Instruction 24-946020Fyrite® INSIGHTInstruction 24-946021Fyrite® INSIGHT4.0 OPERATION4.1 Operating TipsWhen an analyzer is brought in from a cold ve

Instruction 24-946022Fyrite® INSIGHTInstruction 24-946023Fyrite® INSIGHT4. Press ENTER to save the selection and re-turn to the Combustion Test HOLD s

Instruction 24-946024Fyrite® INSIGHTInstruction 24-946025Fyrite® INSIGHT4.6 Making a Draft / Pressure MeasurementThe difference in pressure (ΔP) betwe

Instruction 24-946026Fyrite® INSIGHTInstruction 24-946027Fyrite® INSIGHTsured. The differential pressure between the two areas is now displayed on the

Instruction 24-946028Fyrite® INSIGHTInstruction 24-946029Fyrite® INSIGHT4.11 Powering OFF the Analyzer & PurgingPower OFF the analyzer by pressing

Instruction 24-946030Fyrite® INSIGHTInstruction 24-946031Fyrite® INSIGHT4.14 Printing Test DataCombustion, pressure, or temperature data that is curr

Instruction 24-946032Fyrite® INSIGHTInstruction 24-946033Fyrite® INSIGHTWhen first connected, a “Found New Hardware Wizard” screen will be displayed.

Fyrite® INSIGHTInstruction 24-9460iWARRANTYBacharach, Inc. warrants to Buyer that at the time of delivery this Product will be free from defects in ma

Instruction 24-946034Fyrite® INSIGHTInstruction 24-946035Fyrite® INSIGHT5.0 CALIBRATION & MAINTENANCEIMPORTANT: Before performing any calibration

Instruction 24-946036Fyrite® INSIGHTInstruction 24-946037Fyrite® INSIGHT2. Allow the analyzer to cycle through its 60 second warm-up period. During

Instruction 24-946038Fyrite® INSIGHTInstruction 24-946039Fyrite® INSIGHTProcedure:NOTE: The unit-of-measure for pressure is selected per Section 3.5.3

Instruction 24-946040Fyrite® INSIGHTInstruction 24-946041Fyrite® INSIGHT2. If not already done, turn ON the analyzer and display the CALI-BRATION LIST

Instruction 24-946042Fyrite® INSIGHTInstruction 24-946043Fyrite® INSIGHT“Measured” is the current temperature reading, while “Applied” is a known temp

Instruction 24-946044Fyrite® INSIGHTInstruction 24-946045Fyrite® INSIGHTIf the sensor’s output is too low to be usable, then the message “Bad Calibrat

Instruction 24-946046Fyrite® INSIGHTInstruction 24-946047Fyrite® INSIGHT6.3 O2 Sensor ReplacementMaterial Required: • O2 Sensor (P/N 24-0788) Fyrite®

Instruction 24-946048Fyrite® INSIGHTInstruction 24-946049Fyrite® INSIGHT6.4 CO Sensor Replacement Material Required: • CO Sensor (P/N 24-7265) or B-

Instruction 24-946050Fyrite® INSIGHTInstruction 24-946051Fyrite® INSIGHT7. Strip 1/4 inch of insulation from each of the probe’s thermocouple connect

Instruction 24-946052Fyrite® INSIGHTInstruction 24-946053Fyrite® INSIGHT Main Diagnostics - Lists the current status of the Stack and Air Ther-mocoupl

Fyrite® INSIGHTInstruction 24-94601Fyrite® INSIGHTInstruction 24-9460ii1.0 INTRODUCTION1.1 The Fyrite® INSIGHTThe Fyrite® INSIGHT is a hand-held resid

Instruction 24-946054Fyrite® INSIGHTInstruction 24-946055Fyrite® INSIGHT7.0 PARTS & SERVICE7.1 Replacement PartsDescription Part No.O2 Sensor ...

Headquarters:621 Hunt Valley Circle, New Kensington, PA 15068Ph: 724-334-5000 • Fax: 724-334-5001 • Toll Free: 800-736-4666Website: www.bacharach-inc.

Instruction 24-94602Fyrite® INSIGHTInstruction 24-94603Fyrite® INSIGHTDISPLAY ZOOM - Combustion test data in the Run/Hold screens can be shown with en

Instruction 24-94604Fyrite® INSIGHTInstruction 24-94605Fyrite® INSIGHT1.3 Operational OverviewPressing the PWR button turns the analyzer ON. Note that

Instruction 24-94606Fyrite® INSIGHTInstruction 24-94607Fyrite® INSIGHTGeneral Characteristics:Power Requirements Four disposable ‘AA’ Alkaline batteri

Instruction 24-94608Fyrite® INSIGHTInstruction 24-94609Fyrite® INSIGHTInspect the flue-gas hose for cracks. If a hose is defective, replace the en-tir

Instruction 24-946010Fyrite® INSIGHTInstruction 24-946011Fyrite® INSIGHT 3.5 Setup ModeThe analyzer is preset at the factory for the parameters shown

Instruction 24-946012Fyrite® INSIGHTInstruction 24-946013Fyrite® INSIGHT3.5.3 Pressure UnitsSelect to display pressure in inches of water column (inwc