Bacharach 800 Betriebsanleitung PDF herunterladen

FLORITE

800

INSTRUCTION 16-9013

Installation/Operation/Maintenance

Rev. 3 – March 2004

Bacharach, Inc.

621 Hunt Valley Circle, New Kensington, PA 15068

Phone: 724-334-5000 • Fax: 724-334-5001 • Web: www.bacharach-inc.com

Printed in U.S.A.

® Registered Trademarks of

Bacharach, Inc.

Introduction

The Florite 800 is a battery powered, hand held instrument with a digital LCD

display capable of measuring the velocity, volume ﬂowrate and temperature

of air by means of a thermal probe. The unit allows the airstream area to be

entered for volume measurement. Measurements may be displayed in either

Metric or Imperial units as selected from the keyboard. After selection, this

will be ‘remembered’ by the instrument until reselected from the keyboard. The

attached thermal anemometer probe has a tip diameter of 1/4" (8mm) and is,

therefore, suitable for measurements at grilles, slot diffusers and in small ducts

where large access holes are not acceptable. The velocity sensor in the probe

is compensated for variations in airstream temperature by means of a second

thermistor which also senses, and displays, the actual airstream temperature in

either metric or imperial units consistent with the units selected for velocity.

The instrument is supplied with batteries. Four 1.5 volt ‘AA’ size cells are re-

quired which may be either disposable or rechargeable types. Either Standard

or Alkaline disposable cells may be used but the Standard type will exhibit a

relatively short life and are, therefore, not recommended. Low battery condition

is indicated by ‘LOBAT’ appearing on the instrument display. The cells must be

replaced as soon as possible to maintain optimum accuracy. The battery cells are

accessible by sliding the cover (at th e rear of the instrument case) in the direc-

tion of the arrow. A tape is provided in the battery compartment for easy removal

of the battery cells. Ensure that the battery cells are replaced with the correct

polarity as indicated in each cell compartment. Rotate the cell slightly forwards

and backwards to check that the cell is properly seated in the cell compartment.

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - INSTRUCTION 16-9013

FLORITE® 800INSTRUCTION 16-9013Installation/Operation/MaintenanceRev. 3 – March 2004Bacharach, Inc.621 Hunt Valley Circle, New Kensington, PA 15068Pho

Seite 2 - Key Functions

2 Instruction 16-9013 Florite 800Key FunctionsPressing the ON/OFF key will alternately switch the instrument ON and OFF. When ﬁrst turned ON, all dis

Seite 3 - Instruction 16-9013 3

Instruction 16-9013 3Florite 800This is a dual function key. In either the Velocity or Volume modes, this key allows the unit to be changed sequentia

Seite 4 - Using the telescopic probe

4 Instruction 16-9013 Florite 800When in the averaging mode, this key displays the maximum, mini-mum, and average reading during the averaging period

Seite 5 - Checking the Instrument

Instruction 16-9013 5Florite 800Where to Use the InstrumentLarge Areas: When measuring velocity or volume ﬂowrate over a large area, a number of read

Seite 6 - Service and Recalibration

6 Instruction 16-9013 Florite 800HELP Routine: ( Code 11332 ) The unit will display ‘HELP’ for a period of two seconds, and will then display all the

Seite 7 - Speciﬁcations

Instruction 16-9013 7Florite 800SpeciﬁcationsParameter Metric Mode Imperial ModeVelocity Range 0–30 m/sec 0–6000 ft/minVolume Range 0–2700 m3/sec 0–9

Seite 8

Kommentare zu diesen Handbüchern

Keine Kommentare

Bacharach 800 Betriebsanleitung

Stöbern Sie online oder laden Sie Betriebsanleitung nach Kohlenmonoxid (CO) -Detektoren Bacharach 800 herunter. Bacharach 800 Operating instructions Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kohlenmonoxid (CO) -Detektoren Bacharach 800